Speaker test

Check left, right, the full frequency range and wiring phase.

30

Start at a low volume before turning it up.

How to test your speakers

  1. Click Left, then Right, to confirm sound comes from the correct side.
  2. Click Play sweep to check the full frequency range for rattles or dead spots.
  3. Turn on Invert right channel to check your speakers are wired in phase.

Typical frequency range by speaker type

Speaker typeTypical rangeNotes
Phone speakerAbout 300 Hz to 16 kHzSmall driver, little to no real bass
Laptop speakersAbout 150 Hz to 18 kHzLimited bass, can sound thin at low volume
Desktop or bookshelf speakersAbout 60 Hz to 20 kHzFuller sound, still light on deep bass without a subwoofer
Speakers with a subwooferAbout 20 Hz to 20 kHzClosest to the full range of human hearing

Use the sweep to hear where your own setup starts to fade. A sweep that goes quiet or disappears well before 20 kHz, or below around 60 Hz, simply reflects the speaker's design, not a fault.

Fixing left, right or no sound issues

  • On Windows 11, open Settings, then System, then Sound, select your output device, and open its properties, or use the classic Sound control panel's Playback tab, Properties, Levels tab for a Balance control.
  • On macOS, open System Settings, then Sound, select the Output tab, and adjust the Balance slider near the bottom.
  • Try a different cable or adapter if one channel is silent on wired headphones or speakers, since a damaged 3.5mm plug commonly loses just one side first.
  • Confirm the correct output device is selected at all, especially after connecting or disconnecting Bluetooth speakers or a monitor with built-in speakers.

How the channel and phase checks work

The left and right buttons play the same tone panned fully to one side using the browser's audio panning, so any sound from the wrong speaker, or from both at once, points to a wiring or output setting problem rather than the test.

Inverting the right channel flips its waveform upside down. Correctly wired speakers working together should sound thinner and less focused with the invert switch on, since the two speakers partly cancel each other out. If flipping it sounds the same as normal, or fuller, one speaker may be wired with reversed polarity.

Speaker test FAQ

What does the phase check do?

It reverses the right channel's signal. With correctly wired speakers this makes bass sound thin and the stereo image spread out, since the two speakers are now working against each other.

Why can't I hear anything above a certain pitch?

Most speakers, especially small laptop and phone speakers, roll off well before 20 kHz. Human hearing also gets less sensitive to very high pitches with age.

Should I test with headphones or speakers?

Both work. Headphones make left and right separation and phase differences much easier to hear than open room speakers.

Why does the sweep sound louder in the middle than at the ends?

Human hearing is most sensitive around 1 to 5 kHz and less sensitive at very low and very high frequencies, so a sweep at a constant volume sounds uneven even from perfect speakers.

Why does only one side play through my headphones?

Check that the plug is pushed all the way into the jack. A 3.5mm connector has separate contacts for left, right and ground, and a loose connection commonly mutes just one channel.

Can this test find a blown speaker driver?

It can help you notice a speaker producing no sound, obvious distortion, or output that is much weaker than the other side. Confirming a truly blown driver usually needs the speaker examined outside its enclosure.

Does this work with a soundbar or home theater system?

Yes, as long as that system is set as the active output device on your computer or phone. The left, right and sweep tests play through whichever speakers your device is currently sending sound to.

Related tools